Vaisala HMM100 - Manual (Page 40)

User's Guide _______________________________________________________________________
38 ___________________________________________________________________ M211024EN-C
Example (shows default values):
>li
Cp offset : 0 ?
Cp gain : 1 ?
RH offset : 0 ?
RH gain : 1 ?
T offset : 0 ?
T gain : 1 ?
>save
Saving settings...done
>
Zero the Trimmers
After physically turning the trimmers to zero, use the ZERO command
to set the correction by trimmers to exactly zero. It is easy to introduce a
small, unwanted correction even if trying to zero the trimmers exactly.
This command eliminates the unwanted correction.
ZERO<cr>
NOTE Remember to save the changes!
Example:
>zero
Trimmer positions set to zero.
>save
Saving settings...done
>