Vaisala HMM100 - Manual (Page 32)

User's Guide _______________________________________________________________________
30 ___________________________________________________________________ M211024EN-C
List of Serial Commands
All commands can be issued either in uppercase or lowercase.
The notation <cr> refers to pressing the carriage return (ENTER) key on
your computer keyboard. Enter a <cr> to clear the command buffer
before starting to enter commands.
Table 6 Basic Serial Commands
Command Description
? Show module information
?? Show module information (when in poll
mode)
ADDR [0 ... 99] Set the module address (for POLL mode)
CALCS Show measured quantities
CLOSE Close the temporary connection (returns to
POLL mode)
ECHO [ON/OFF] Set terminal echo
ENV Set environmental parameters
ERRS Display active errors
HELP List available commands
INTV [ 0 ... 255 S/MIN/H] Set the continuous output interval
(for RUN mode)
OPEN [0 ... 99] Open a temporary connection to a POLL
mode device
PASS [passcode] Access advanced commands (requires
passcode)
R Start the continuous outputting
RESET Resets the module
RESTORE Restores the latest saved settings
(overwrites unsaved settings)
S Stop the continuous outputting
SAVE Save changed settings to memory
SEND [0 ... 99] Output the reading once
SERI [baud p d s] User Port settings (Default: 19200 N 8 1)
baud: 300 ... 115200
STATUS Show analog output status
SYSTEM Show module information and build date
VERS Show software version of the module
XPRES Set the value for pressure compensations,
temporarily