Hoshizaki KM-1601SWH/3 - Manual (Page 27)

27
1) Remove the louver panel. See Fig. 15.
2) Remove the junction box cover on the remote condenser unit. Remove the fan motor
junction box cover on the icemaker.
3) Install a ground wire from the icemaker to the remote condenser unit. Use wire of an
appropriate gage and outdoor rating.
4) Install line and neutral wires from the fan motor leads in the icemaker to the leads in
the remote condenser unit junction box. Use wire of an appropriate gage and outdoor
rating.
5) Replace the junction box covers and the louver panel in their correct positions.
7. Stacking Condenser Unit
1) Install the lower remote condenser unit as described earlier in this section.
2) Place the upper remote condenser unit on top of the lower. See Fig. 16.
3) Secure the upper remote condenser unit to the lower remote condenser unit with the
4 screws provided.
4) Install refrigerant lines and make electrical connection as described earlier in this
section.
Fig. 15
Screws
Louver Panel
Junction Box
Cover
Remote Condenser Unit Icemaker
Screw
Fan Motor Junction
Box Cover
Fig. 16
Upper Remote
Condenser Unit
Screws
Lower Remote
Condenser Unit
Screws