Fluke RUSKA 7350 - Manual (Page 25)

4-1
Chapter 4
Local Operation
Local Operation
This section of the manual describes operation of the Calibrator using the front panel.
The local interface (front panel) consists of a color TFT display, a rotary knob and a set
of keys. The display shows the system status and menu options. The keys are grouped
according to function.
gld03.bmp
Figure 4-1. RUSKA 7350 Front Panel
Numeric Keypad
This includes the number keys, the decimal point [.], and the change sign key [-]. The
UNITS key changes between units of measure, MODE changes between modes of
operation such as gauge and absolute, MEASURE is used to place the unit into measure
mode. CLEAR key will clear the numeric entry field. The ENTER key accepts the
entered number or confirms a command.
Function Keys
These are the six keys that run vertically beside the display. The label shown in the
display beside each key identifies their function. These functions will change based on
which screen you are operating. For ease of communication, throughout the manual we
refer to these keys as [F1] through [F6]. We consider the top key to be F1 and the
bottom F6.
Rotary Knob
The rotary knob selects a field for editing and is used for small pressure changes
(pressure jog) at the main menu.