Furuno NAVNET 1724C - Manual (Page 117)

3. PLOTTER OPERATION
3-46
Restarting navigation
When you steer to avoid an obstacle or the vessel drifts, you may go off your intended
course, as in Line 1 in the figure below. Also, if you don’t need to return to the original
course, you can go directly to the next waypoint, as in Line 2 in the figure below. In these
cases, use the restart navigation function to restart navigation.
Original course
Obstacle
Line 1
Line 2
Example of when to restart navigation
1. Press the MENU key to open the menu.
2. Press the WAYPOINTS/ROUTES soft key.
3. Press the LOG soft key.
Estimated Time of Arrival at destination
Passed waypoint (gray characters)
Destination waypoint (Waypoint name in reverse video)
Replaces triangle
when selecting a
route leg.
LOG
RE-
START
STOP
RVRSE
SPEED
COORD
TYPE
Replaced by
"FOLLOW LEG"
when selecting
a route leg.
▲
29.9 °
12.0nm
159.9 °
6.00nm
50.5 °
29.8nm
359.9 °
3.0nm
LEG 01 34 ° 44.111'N
135 ° 21.134'W 001WPT
34 ° 43.432'N
135 ° 41.456'W 003WPT
03 34 ° 14.124'N
135 ° 21.567'W 002WPT
04 34 ° 44.569'N
135 ° 21.152'W 005WPT
05 34 ° 54.124'N
135 ° 21.888'W 008WPT
ETA 23:59 11.FEB
02
Log display
4. Use the Cursor pad to select a waypoint or a route leg. When a route leg is selected
the single arrow cursor is replaced by double arrows.
5. Press the RESTART soft key or FOLLOW LEG soft key in case of route leg.
RESTART: Line2 in the figure above
FOLLOW LEG: Line 1 in the figure above
6. Press the MENU key to close the menu.