Furuno NAVNET 1724C - Manual (Page 24)

1. OPERATIONAL OVERVIEW
1-11
1.5.4 Selecting image source
When more than one network radar or network sounder is connected to the equipment, you
may select an image source for each as shown below. This is not necessary when only one
network radar or network sounder is connected.
1. Press the DISP key.
2. Press any soft key to show the following display.
RADAR SOURCE
1 (HOST NAME: NAVNET1)
SOUNDER SOURCE*
SOUNDER
_
IP ADDRESS
172.031.003.003
DEVICE NUMBER
2 (HOST NAME: NAVNET2)
▲
SELECT
SOURCE
EDIT
RETURN
IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.
*: Do not change this setting.
Select source menu
3. Use the Cursor pad to select RADAR SOURCE, SOUNDER SOURCE or AUX
SOURCE as appropriate, then press the EDIT key.
Radar source
RADAR SOURCE
▲
¤ 1 (NAVNET1)
¡ 2 (NAVNET2)
¡ 3 (NAVNET3)
¡ 4 (NAVNET4)
▼
SOUNDER SOURCE
▲
¤ ETR0 (SOUNDER)
¡ ETR1 (SOUNDER1)
¡ ETR2 (SOUNDER2)
¡ ETR3 (SOUNDER3)
¡ ETR4 (SOUNDER4)
¡ ETR5 (SOUNDER5)
¡ ETR6 (SOUNDER6)
¡ ETR7 (SOUNDER7)
¡ ETR8 (SOUNDER8)
¡ ETR9 (SOUNDER9)
▼
Sounder source
Radar source and sounder source windows
4. Use the Cursor pad to choose source.
5. Push the ENTER knob to set.
6. Press the DISP key to finish.
7. Turn the power off and on again.