Furuno NX-300 - Manual (Page 41)

4-1
4. OTHER FUNCTIONS
4.1 DEMO Mode
The DEMO mode provides simulated operation of this unit. Connection of antenna is not
necessary. You may select stations and messages manually or automatically and demo
messages are received. All controls are operative.
Note: Turning on the DEMO mode erases all messages.
Press the [PWR] key while pressing to turn the power on. “SET DEMO MODE!” appears
momentarily. “DEMO” appears at the top of the screen when the DEMO mode is active.
Figure 4-1 Message display
To escape the DEMO mode, press the [PWR] key while pressing . “RESET DEMO MODE!”
appears momentarily.
4.2 VIEW Mode
The NX-300 ordinarily displays messages in their entirety. The VIEW mode, however displays
messages character by character.
Press the [PWR] key while pressing  to turn the power on. “SET VIEW MODE!” appears
momentarily. “VIEW” is displayed at the upper left corner of the display.
To quit the VIEW mode,: repeat above procedure. “RESET VIEW MODE!” appears.
4.3 All Clear
This function deletes all messages and restores default settings. When the NX-300 is first
installed, you should clear all data.
Press the [PWR] key while pressing  to turn the power on. “RESET BACKUP DATA!” appears
momentarily while data is being cleared. Then, all default settings are restored.
DEMO mark