FARGO electronic DTC500 - Manual (Page 175)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0) 175
Defining the Area to activate the Card Grid
Step Procedure
1 Select on the appropriate Defined Area (see below) to activate the card grid in the
upper half of the window. (Note: It is through this card grid that up to five areas
can be defined, as shown below.)
When the card grid is first activated, a small black square will appear at its:

default size of .2" x .2" (5mm x 5mm)

default location in the lower left-hand corner (0,0)
(Note: This square represents the first defined area.)