Defining the positioning of the area on the card, Karen atkins – FARGO electronic DTC500 User Manual
Page 178
Advertising
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
178
Defining the positioning of the area on the Card
Step
Procedure
1
Once the area is sized properly, measure the location where this area is to be
positioned on the card.
a. Measure from the lower left corner of the card up and over to the lower left
corner of where the defined area is to begin.
b. Enter these values into the X and Y boxes, as shown below.
c. Note that the card grid lines are spaced at .2
”
(5mm) intervals.
* 172355*
Karen Atkins
Access Level-2
ID# 1234478
Y=0.2
“
X=1.4
“
Advertising