Frymaster 45 - Manual (Page 51)

MASTER JET SERIES ATMOSPHERIC GAS FRYERS
CHAPTER 6: OPERATOR TROUBLESHOOTING
6-8
6.6 Replacing the Controller or Controller Wiring Harness
1. Disconnect the fryer from the electrical
supply.
2. Remove the two screws in the upper
corners of the control panel and swing
the panel open from the top, allowing it
to rest on its hinge tabs.
3. Disconnect the wiring harness from the
back of the controller and, if replacing
the harness, disconnect it from the
interface board (arrows).
4. If replacing the controller, disconnect
the ground wire and the 15-pin
connector (arrows), and then remove the
controller by lifting it from the hinge
slots in the control panel frame.
5. Reverse the procedure to install a new
controller or wiring harness.
If replacing harness, disconnect the harness from
the controller and interface board (arrows).
If replacing controller, disconnect the ground wire
and the 15-pin connector (arrows).