Frymaster 45 - Manual (Page 9)

MASTER JET SERIES ATMOSPHERIC GAS FRYERS
CHAPTER 1: INTRODUCTION
1-5
1.5.2 Model Applications (cont.)
All models except J1C Series fryers may be equipped with optional built-in filtration systems. All
models except J1C and MJ35 Series fryers may be configured for electrical power supplies ranging
from 120 to 240 VAC.
All models are of an open-pot design and have a hand-sized opening into the deep cold zone, which
makes cleaning the stainless frypot quick and easy.
Fryers equipped with built-in filtration systems are shipped completely assembled. Fryers without
built-in filtration require installation of legs or optional casters at point of use (J1C Series not
available with casters). All fryers are shipped with a package of standard accessories. Each fryer is
adjusted, tested, and inspected at the factory before crating for shipment.
Frypots are constructed of welded, heavy-gauge cold-rolled steel or stainless steel. Heating is
supplied by a burner assembly having multiple gas jets, which are focused on ceramic targets located
around the lower side of the frypot. The burner assembly can be configured for natural gas, propane,
or manufactured gas. The frypot is drained with a manual ball valve.
Master Jet Series Atmospheric fryers are equipped with a thermostat probe for precise temperature
control. The probe is located on the centerline of the frypot for rapid response to changes in loads
and to provide the most accurate temperature measurement.
Master Jet Series Atmospheric fryers may be equipped with an optional melt cycle feature (not
applicable to J1C and MJ35 Series), which pulses the burner on and off at a controlled rate. The
melt cycle feature is designed to prevent scorching and uneven heating of the frypot when using
solid shortening.
Controls on Master Jet Series Atmospheric fryers vary depending on the model and configuration
purchased. Control options can include thermostat controls, solid-state (analog) controllers, digital
controllers, or Computer Magic III.5 computers. Not all models are available with all controller
options. Each type is covered in detail in the separate Frymaster Fryer Controllers User’s Manual
provided with your equipment.
1.6 Installation, Operating, and Service Personnel
Operating information for Frymaster equipment has been prepared for use by qualified and/or
authorized personnel only, as defined in Section 1.7.
All installation and service on Frymaster equipment must be performed by qualified, certified,
licensed, and or/authorized installation or service personnel, as defined in Section 1.7.