Farallon Communications QMS 4525 - Manual (Page 111)

Printer Fails to
Print
6-11 Troubleshooting
When You Have Finished
Once all jammed paper has been removed, press the Continue key
on the control panel. The printer then resumes printing, starting with
those not properly deposited in the standard output bin when the jam
occurred. You must then reprint any damaged pages.
• 1RWH ,IWKHVDPHSDSHUMDPRFFXUVRIWHQPDNHVXUH\RXDUHXVLQJDSDSHU
VL]HDQGZHLJKWWKDWLVVXSSRUWHGE\WKHSULQWHU7KHQVHHWKDWWKHSDSHULV
FRUUHFWO\VWDFNHGLQWKHSDSHULQSXWELQRUDOLJQHGLQWKHPDQXDOIHHGVORW
DQGPDNHVXUHWKHFORVXUHSODWHLVFRUUHFWO\SRVLWLRQHGDQGDOLJQHGDJDLQVW
WKHULJKWKDQGHGJHRIWKHSDSHUVWDFN
Printer Fails to Print
If the printer is on but does not print when a job is sent to it, use the
following procedure to identify and correct the problem.
1 Check the control panel for an error message and correct
any indicated problem. Refer to “Control Panel Status Mes-
sages” later in this chapter.
2 Make sure the printer is on line. The On indicator must be lit;
if it is not, press the Line key to place the printer on line.
3 If the message
SERVICE CALL XXX
displays, the printer has detected a serious error. Call QMS
Customer Technical Assurance (CTA). Refer to appendix A,
"QMS Customer Support," for information on how to contact
CTA.
4 Check the host from which the job was sent for a message.
Correct the indicated problem, if any.
5 Check the host connection to the printer.