Farallon Communications QMS 4525 - Manual (Page 115)

Control Panel
Status Messages
6-15 Troubleshooting
CREATING xxxxxxxxxxxxxxx FILE, PLEASE WAIT
Indicates that the specified accounting file is created when accounting is
enabled and the files are not in existence or these files are created following a
Reset Accounting. (
XXXXXXXXXXXXXXXX represents the Job Accounting or
Paper Accounting file.
ENGINE ERROR 20
Indicates that the buffer speed is out of specification during scan. The printer
displays this warning error and continues to print the job.
ENGINE ERROR 21
Indicates that the buffer did not reset at the start of a print cycle. The printer
continues to print the job.
ENGINE ERROR 22
Indicates that the buffer did not give the SOP signal in time. The printer
continues to print.
ENGINE ERROR 24
Indicates that no PAV signal was received after the SOP has been
transmitted. The printer continues to print the job.
ENGINE ERROR 30
Indicates that the corona did not charge. The printer continues to print the job.
ENGINE ERROR 40
Indicates the side framing lamps A and /or B failed. The printer continues to
print the job.
ENGINE ERROR 41
Indicates that the side framing lamp C failed. The printer continues to print the
job.
ENGINE ERROR 50
Indicates that both cross framing lamps failed. The printer continues to print
the job.
ENGINE ERROR 90
Indicates that the TTF temperature is out of specification. The printer
continues to print the job.
ENGINE ERROR 91
Indicates that the feed plate temperature is out of specification. The printer
continues to print the job.