Furuno GP-36 - Manual (Page 26)

3-4
Figure 3-11 Screen appearance when
MOB is set as destination
3.3 Displaying Waypoint Name
You may display on the plotter display all
waypoint names or only the GOTO
waypoint name as follows:
1. Press the [MENU] key once or twice to
display the menu.
2. Select PLOTTER and press the [ENT]
key.
3. Place the cursor on the WYPT NAME
field and press the [ENT] key. The fol-
lowing window appears.
Figure 3-12 DSP GOTO, DSP ALL
selection window
4. Select DSP GOTO or DSP ALL as ap-
propriate and press the [ENT] key.
5. Press the [MENU] key twice to finish.
3.4 Editing Waypoints on the
WPTS/MRKS List
Waypoint position, waypoint name, mark
shape and comment can be edited on the
WPTS/MRKS List.
1. Press the [MENU] key once or twice to
display the menu.
2. Select WAYPOINTS and press the
[ENT] key.
3. Select LIST or NEAREST and press the
[ENT] key.
4. Select waypoint to edit and press the
[ENT] key.
Note: CURSOR, MOB or START are
automatically updated according to
destination
setting or MOB
setting.Therefore,editing these items
has no meaning.
5. Select the NAME field and press the
[ENT] key.
6. Change name with the cursor pad and
press the [ENT] key. You are then asked
if you want to create or rename the
waypoint, or quit (escape) this display.
Figure 3-13 CREATE, RENAME prompt
7. Select objective and press the [ENT]
key.
8. Change position, mark shape, comment
as desired.
9. Select “Exit?” and press the [ENT] key.
10.Press the [MENU] key twice to finish.