Furuno GP-36 - Manual (Page 62)

9-4
Output setting
1. Press [MENU] once or twice to open the
menu.
2. Operate the cursor pad to select I/O
SETUP.
3. Press the [ENT] key.
I/O SETUP
DATA1 : NMEA-REM1
DATA2 : NMEA-REM
NMEA VER : VER2.0
SAVE WP/RTE
→
PC?
LOAD WP/RTE
←
PC?
LOAD WP
←
YEOMAN?
WIRING INFO?
Figure 9-5 I/O SETUP menu
4. To change setting, press ▼ to select
DATA1, DATA2 or NMEA VER as ap-
propriate.
5. Press the [ENT] key. One of the follow-
ing screens appears depending on the
item selected at step 4.
NMEA REM1
NMEA REM2
NMEA AP
For DATA1
NMEA REM
NMEA AP
RTCM-OUT
For DATA2*
VER 1.5
VER 2.0
For NMEA
Version
* BEACON displayed when
DGPS setting is EXT.
Figure 9-6 Screens for setup of data
output and selection of NMEA version
6. Select desired option with ▲ or ▼ .
NMEA-REM1, 2: Output data to radar,
echo sounder, etc.
NMEA-AP: Output data to an autopilot.
RTCM-OUT: Select when equipped with
internal DPGS beacon receiver.
VER 1.5, 2.0: Select NMEA version of
external equipment. If you are unsure
of NMEA version no., try both and se-
lect the one which successfully outputs
data.
7. Press the [ENT] key.
8. Press the [MENU] key to finish.