Furuno GP-36 - Manual (Page 52)

7-12
6. Press the [ENT] key.
Note: The waypoint and route data are
deleted when the [ENT] key is pressed.
Figure 7-28 Display when data
is being loaded
7. When the loading is completed, the fol-
lowing message appears.
Figure 7-29 Display when data
is loaded successfully
8. Press any key to escape.
Loading data from a YEOMAN
Waypoint data from a YEOMAN has the
same format as does the NMEA 0183 data
sentences WPL.
1. Press the [MENU] key twice, select I/O
SETUP and press the [ENT] key.
2. Select LOAD WP
←
YEOMAN?.
3. Press the [ENT] key.
Figure 7-30 LOAD WP/RTE display
4. Press the [ENT] key.
Figure 7-31 LOADING START? prompt
5. Set up the YEOMAN to output data.
6. Press the [ENT] key.
Figure 7-32 Display when data
is being loaded
7. Press the [ENT] key to start the load-
ing. Data is loaded to empty location and
the buzzer sounds twice to signify suc-
cessful loading. If there is not enough
memory free to store the waypoints the
message below appears.
Figure 7-33 Display when waypoints
could not be loaded
Waypoint data format
Figure 7-34 Waypoint data format
1: Waypoint latitude
2: N/S
3: Waypoint longitude
4: E/W
5: Waypoint name (Number of characters
is fixed to 6 and space code is placed