Genie AWP 114002 - Manual (Page 22)

Operator’s Manual Third Edition • Fourth Printing
20 Genie AWP Super Series Part No. 114002
OPERATING INSTRUCTIONS
Emergency Stop
Push in the red Emergency Stop button at the
platform controls or at the ground controls to stop
the up function.
Platform Raise and Lower
1 Pull out the red Emergency Stop button to the
on position at the ground controls. Twist to
release the red Emergency Stop button at the
platform controls.
2 Push in the control activate button and rotate
the up/down switch in the desired direction of
travel.
Manual Lowering
1 Activate the manual
lowering valve located
at the bottom of the
hydraulic cylinder.
Auxiliary Platform Lowering
- AC & DC Models
1 Turn the key switch to ground control. Pull out
the red Emergency Stop button to the on
position.
2 Activate the auxiliary platform lowering button at
the ground controls.
Fall Protection
Personal fall protection equipment (PFPE) is not
required when operating this machine. If PFPE is
required by job site or employer rules, the following
shall apply:
All PFPE must comply with applicable
governmental regulations and must be inspected
and used in accordance with the manufacturer’s
instructions.
After Each Use
1 Select a safe storage location—firm, level
surface, weather protected, clear of obstruction
and traffic.
2 Chock the wheels to prevent the machine from
rolling.
3 Remove the key to secure from unauthorized
use.
4 DC models: Recharge the battery.