Genie AWP 114002 - Manual (Page 25)

Operator’s Manual Third Edition • Fourth Printing
Part No. 114002 Genie AWP Super Series 23
Loading for Transport
1 Fully lower the platform.
2 Push in the red Emergency Stop buttons, turn
the key switch to the off position and remove
the key.
3 Remove the outriggers from the base and place
them in the storage sockets.
4 DC models: Disconnect the battery cable and
remove the battery pack.
5 Inspect the entire machine for loose or
unsecured items.
6 Slide the stop bracket to the top lock position.
a stop bracket
b loading pivot
All models without tilt-back frame
a stop bracket
b loading pivot
All models with tilt-back frame
7 Hook the loading pivot to the stop bracket.
TRANSPORT INSTRUCTIONS
8 Position the machine
flush against the
loading surface.
Lower and lock the
stop bracket to the
lowest lock pin
position above the
loading surface.
9 All models with tilt-back frame:
Be sure both stop bracket lock pins are fully
locked.
Be sure both tilt-back frame swivel casters are
locked.
10 Slide out the T-handle until the lock pin snaps
into place.
11 Lift the T-handle to
tilt the machine
onto the loading
surface. Use the
appropriate number
of people and
proper lifting
techniques.
12 Carefully push
the machine into
the transport
position.
13 Return the sliding
T-handle to the
stowed position.
14 Secure the machine base and mast to the
transport vehicle. See Securing the Machine on
the next page.
15 Reverse this procedure to unload the machine.
a
b
a
b