Genie AWP 114002 - Manual (Page 29)

Operator’s Manual Third Edition • Fourth Printing
Part No. 114002 Genie AWP Super Series 27
Returning the Machine to
Standing Position
1 Be sure the area below the machine base and
T-handle is clear of personnel and obstructions.
2 Slide out the T-handle
untl the lock pin snaps
into place.
3 Carefully pull down the
T-handle until the
machine rests at mid-
tilt position.
4 Lower the machine with
the T-handle until the base casters are in
contact with the ground. Use the appropriate
number of people and proper lifting techniques.
5 Return the sliding T-handle to the stowed
position.
TILTBACK OPERATION INSTRUCTIONS
Stowing the Tilt-back Assembly
1 Remove the retaining pin.
2 Firmly grasp the
tilt-back frame and
remove the
tilt-back strut from
the strut socket.
3 Lift the tilt-back
frame, hold in an
upright position
against the spring
and secure with
the retaining pin.