Grizzly G0622 - Manual (Page 14)

-12-
Model G0622 (Mfg 2/08+)
Inventory
Inventory: (figure 3) Qty
A. Bandsaw (not shown) ................................. 1
B. Stand legs ................................................. 2
C. tool tray ..................................................... 1
D. Corner Support Braces .............................. 4
E. Wheels ....................................................... 2
f. Axle ............................................................ 1
G. Wheel Mounting Bracket ............................ 1
h. Work Stop rod ........................................... 1
I. Work Stop ................................................... 1
J. transport handle ........................................ 1
K. pulley Cover ............................................... 1
L. v-Belt .......................................................... 1
M. pulleys with Keys ........................................ 2
N. table ........................................................... 1
O. table Support ............................................. 1
hardware Bag (not shown)
•
hex Wrench 4mm (Work Stop) .................. 1
• hex Bolt M8-1.25 x 25 (Saw to Stand) ....... 6
• hex nut M8-1.25 (Saw to Stand) ................ 6
• Flat Washer 8mm (Saw to Stand) .............. 6
• hex Bolt M6-1 x 12 (Stand) ........................ 8
• phillips head Screw M6-1 x 12 (tray) ........ 4
• hex nut M6-1 (Stand, tray, table) ........... 13
• Flat Washer 6mm (Stand, tray) ............... 12
• Fender Washer 6mm (table) ...................... 1
• Flat head Screw M6-1 x 12 (table) ............ 1
• Cotter pins (Axle & handle) ....................... 4
figure 3. Model g0622 inventory.
B
C
d
e
F
g
h
i
J
K
l
M
n
o
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.