Grizzly G0622 - Manual (Page 17)

Model G0622 (Mfg 2/08+)
-15-
Assembly
To assemble the bandsaw:
1. Unfold the two stand leg assemblies. they
are hinged on the edges for easy set up.
2. Use the M6-1 x 12 hex bolts, M6-1 hex nuts,
and 6mm flat washers to install the corner
support braces in the bottom corners of the
leg assemblies (
figure 6).
6. on the other leg, insert the handle into the
pre-drilled holes and secure it with the cotter
pins (see
figure 8).
5. Slide the wheels onto the axle on the outside
of the mounting brackets, and secure them
with the cotter pins, as shown in
figure 7.
3. on one of the leg assemblies, attach the
wheel mounting bracket along with the corner
support braces to the outside bottom edge,
as shown in
figure 6.
4. Slide the axle through the holes in the wheel
mounting bracket.
figure 6. Corner braces and wheel bracket.
Corner
Support
Braces
Wheel
Mounting
Bracket
figure 7. Wheel assembly.
Cotter pin
figure 8. Cotter pins installed into
the handle.
Cotter
pin