Grizzly G0622 - Manual (Page 20)

-18-
Model G0622 (Mfg 2/08+)
Starting the machine:
1. read the entire instruction manual.
2. Make sure all tools and foreign objects have
been removed from the machine.
3. Connect the bandsaw to power.
4. put on safety glasses and secure loose cloth-
ing or long hair.
5. raise the bandsaw by the handle.
6. Start the bandsaw while keeping your finger
near the on/oFF switch at all times during
the test run (
figure 17). the bandsaw should
run smoothly with little or no vibration.
— if you suspect any problems, immediately
stop the bandsaw and correct before con-
tinuing.
—if you need any help with your bandsaw
call our tech Support at (570) 546-9663.
projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
the adjustments listed below have been per-
formed at the factory. however, because of the
many variables involved with shipping, we rec-
ommend that you at least verify the following
adjustments to ensure the adjustments remain
unchanged.
Step-by-step instructions on verifying these adjust-
ments can be found in
SECTION 7: SERvICE
ADJUSTMENTS.
factory adjustments that should be verified:
1. Blade tracking (page 34).
2. Squaring the Blade (page 35).
3. Blade guide Bearings (page 36).
Recommended
Adjustments
figure 17. on/oFF switch.
Test Run