Grizzly G0622 - Manual (Page 23)

Model G0622 (Mfg 2/08+)
-21-
figure 23. Adjusting table level.
5. place a level on the table, as shown in figure
23, then use the adjustment bolt shown in
figure 24 to make the table level.
figure 24. Adjustment bolt.
Adjustment
Bolt
figure 22. table and bracket installed.
Bolt Already
in Casting
vertical Operation
the Model g0622 can easily be set up for vertical
cutting operations.
To assemble the bandsaw for vertical cutting:
1. diSConneCt BAndSAW FroM poWer!
2. remove the two flat head screws and the
blade guide cover shown in figure 21.
3. install the table and replace the two screws
removed in Step 2.
4. install the table bracket with the pre-installed
hex bolt, the M6-1 x 12 flat head screw, and
the M6-1 hex nut, as shown in
figure 22.
figure 21. Blade guide cover.
Blade
guide
Cover