Grizzly G0622 User Manual
Page 19
![background image](/manuals/107088/19/background.png)
Model G0622 (Mfg 2/08+)
-17-
figure 13. Checking pulley alignment.
15. Use a straightedge to check the alignment
of the pulley wheels, as shown in
figure 13,
and adjust them as needed.
16. When the pulley wheels are aligned, tighten
the set screws on both pulleys.
17. Unthread the motor lock bolt, then pivot the
motor up and slide the v-belt into the pulley
grooves, as shown in
figure 14.
18. release the motor, letting its weight tension
the v-belt, then thread the motor lock bolt
against the side of the bandsaw.
19. install the work stop shaft into the side of the
bandsaw then lock it in place by tightening
the set screw, as shown in
figure 15.
figure 15. installing work stop shaft.
20. Slide the work stop onto the end of the shaft
and lock it into position with the locking lever,
as shown in
figure 16.
figure 14. v-belt installation.
Motor lock
Bolt
figure 16. Work stop locking lever.
locking
lever