GE MONOGRAM ZV1050 - Manual (Page 14)

14
Installation Instructions
STEP 10 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
If house wiring is not
2-wire with a ground wire, a ground must be provided
by the installer. When house wiring is aluminum, be
sure to use UL-approved antioxidant compound and
aluminum-to-copper connectors.
AVERTISSEMENT :
Si le
câblage de la maison n’est pas du type à deux fils avec
un fil de terre, l’installateur doit fournir un circuit de
terre. Quand les fils de la maison sont en aluminium,
il prendre soin d’utiliser de la pâte antioxidation
approuvée par UL et des connecteurs pour
l’aluminium-cuivre.
• Install strain relief onto the knockout of the junction
box cover.
• Insert house wiring through strain relief and tighten.
• Connect white leads to branch circuit white lead.
• Connect black leads to branch circuit black lead.
• Connect green/yellow leads to branch circuit green
or bare ground lead.
• Secure all connections with wire nuts on each
electrical connector.
• Push wires into junction box and replace cover.
Be sure wires are not pinched.
STEP 11 SLIDE DUCT COVER DOWN
• Hold the decorative duct cover and remove the
decorative stop screw from the support frame.
Keep the screw.
• Slide the lower duct cover down onto the hood.
• Install the decorative screw in the lower left hole
on the duct cover as shown.
538Dia24
Install
Decorative
Screw