GE MONOGRAM ZV1050 - Manual (Page 5)

5
Advance Planning
TOOLS AND MATERIALS REQUIRED
(not supplied)
• Tape measure
• Knife
• Spirit level
• Wire cutter
• Wire stripper
• Wire nuts
• Electric drill and 5/32" bit
• Phillips screwdriver
• Flat-blade screwdriver
• Hammer
• Pliers
• Safety glasses
• Tape to mount template
• Gloves to protect against sharp edges
• 120V, 60Hz., 15- or 20-Amp, 2 wire with ground, properly grounded
branch circuit
• Strain relief for junction cover
• Plumb bob
• Center punch
POWER SUPPLY
IMPORTANT
– Please read carefully.
WARNING:
FOR PERSONAL
SAFETY, THIS APPLIANCE MUST BE PROPERLY
GROUNDED.
AVERTISSEMENT :
POUR DES RAISONS DE SÉCURITÉ, CET
APPAREIL DOIT ÊTRE CORRECTEMENT
MIS À LA TERRE.
Remove house fuse or open circuit breaker before
beginning installation.
Do not use an extension cord or adapter plug with
this appliance. Follow National Electrical Code
or prevailing local codes and ordinances.
Electrical supply
This vent hood must be supplied with 120V, 60Hz,
connected to an individual, properly grounded
branch circuit, and protected by a 15- or 20-amp
circuit breaker or time-delay fuse.
• Wiring must be 2-wire with ground.
• If the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
• Route house wiring in the ceiling, as close to the
installation location as possible. Allow an additional
3-feet length from ceiling joists to reach the junction
box on the hood.
• Connect the wiring to the house wiring in accordance
with local codes.
Grounding instructions
The grounding conductor must be connected
to a ground metal, permanent wiring system, or an
equipment-grounding terminal or lead on the hood.
WARNING:
The improper connection
of equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician or
service representative if you are in doubt whether the
appliance is properly grounded.
AVERTISSEMENT :
Le mauvais branchement du fil de mise à la terre
peut causer un choc électrique. En cas de doute,
consulter un électricien qualifié ou un technicien
pour déterminer si l’appareil est à la terre.