GE 164D2966P030 - Manual (Page 31)

How to Set Oven for Cleaning
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the CLEAN pad.
4. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
If the oven is too hot and you start to set a clean
cycle, the word
“OFF” will appear in the display.
Allow additional time for cooling before you try
to set the cycle.
NOTE: Only one oven at a time can be self-cleaned.
1. Follow the directions to prepare the oven
for cleaning.
2. Press the CLEAN pad.
f
CLEAN
3. Press the INCREASE or DECREASE
pad until the desired Clean Time
is displayed.
Clean Time is normally 3 hours. You
can change the Clean Time to anytime
between 2 and 4 hours, depending on
the amount of soil in your oven.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the clean
cycle is set. The words “ON” and “LOCK” will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE:
●
The word “door” will be displayed, the word
“LOCK” will flash and oven control will signal
if you set the clean cycle and forget to close the
oven door.
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
STOP
TIME
●
You can find out when the clean cycle
will be finished by pressing the STOP
TIME button.
To Stop a Clean Cycle
❑
1. Press the pad. 2. Wait until the oven has cooled below locking
CLEAR
temperature. You will not be able to open the
OFF
door right away unless the oven is below the
locking temperature.
(continued next page)
31