GE 164D2966P030 - Manual (Page 7)

Clock To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Bake or CLEAN cycle.
❑
1. Press the
CLOCK pad.
CLOCK
2. Press the
A INCREASE or
DECREASE pad
to set the time
of day.
3. Press the CLOCK pad to start.
Timer To Set the Timer
The timer is a minute timer; it does 1. Press the TIMER
not control oven operations: The
maximum setting on the timer is 9
hours and 55 minutes.
TIMER
ONIOFF pad.
ONIOFF
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you
setting it,
will display hours and minutes.
“HR” will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
To Reset the Timer To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or Press and hold the TIMER ON/OFF pad until the
DECREASE pad until desired time is reached. word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
The End of Cycle tone is a series of 3 beeps followed by 1 beep every
6 seconds. If you would like to remove the signal that beeps every 6
seconds, press and hold the pad for 10 seconds.
To return the signal that beeps every 6 seconds, press and hold the
pad for 10 seconds.
Power Outage
After a power outage, when power is restored, the display will flash and
time shown will no longer be correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the power went out will
have to be programmed again.
(continued next page)
7