Grizzly G1010 - Manual (Page 12)

-10-
G1010 4" x 6" Metal-Cutting Bandsaw
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
110/220V Operation
SECTION 2: CIRCUIT REQUIREMENTS
Amperage Draw
The Model G1010 features a 1 ⁄
2
HP 110/220V
motor that is prewired at 110V.
Motor Draw at 110V .................................9 Amps
Motor Draw at 220V .............................4.5 Amps
Circuit Requirements
Only connect your machine to a circuit that meets
the requirements below. Always check to see if
the wires and circuit breaker in your circuit are
capable of handling the amperage draw from
your machine, as well as any other machines that
could be operating on the same circuit. If you are
unsure, consult a qualified electrician.
110V Circuit .............................................15 Amp
220V Circuit .............................................15 Amp
Figure 2. 6-15 plug and outlet.
Plug Type
The Model G1010 comes prewired with a NEMA
5-15 plug. If you wish to rewire the motor to 220V
you will need the following 220V plug (see
Figure
2 for an example):
220V Plug & Receptacle .............................. 6-15
The Model G1010 can be rewired to operate on a
220V power source. The motor must be rewired
according to the wiring diagram on the motor
label. The wiring configuration can also be found
on the inside of the motor wire cover, as well as
on
Page 38.
Wiring for 220V