Grizzly G1010 - Manual (Page 20)

-18-
G1010 4" x 6" Metal-Cutting Bandsaw
Figure 13. Installing pulley cover.
Pulley Cover
Components and Hardware Needed: Qty
Pulley Cover ......................................................1
Pan Head Screw
1 ⁄
4
"-20 x 5 ⁄
8
" ..............................2
To install the pulley cover:
1. Slide the pulley cover over the drive-shaft.
2. Align the holes and secure with the two 1 ⁄
4
"-
20 x 5 ⁄
8
" screws (see Figure 13).
3. Attach the bandsaw to the stand with 8 hex
bolts, 16 flat washers and 8 hex nuts and
tighten with a 12mm wrench (see
Figure
12).
Figure 12. Front view of bolt locations.