Grizzly G1010 - Manual (Page 25)

G1010 4" x 6" Metal-Cutting Bandsaw
-23-
Starting the machine:
1. Read the entire instruction manual.
2. Make sure all tools and foreign objects have
been removed from the machine.
3. Put on safety glasses and secure loose
clothing or long hair.
4. Raise the bandsaw by the handle.
5. Start the bandsaw while keeping your finger
near the ON/OFF switch at all times dur-
ing the test run (
Figure 26). The bandsaw
should run smoothly with little or no vibra-
tion.
— If you suspect any problems, immediately
stop the bandsaw and correct before con-
tinuing.
—If you need any help with your bandsaw
call our Tech Support at (570) 546-9663.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
The adjustments listed below have been per-
formed at the factory. However, because of
the many variables involved with shipping, we
recommend that you at least verify the following
adjustments to ensure the adjustments remain
unchanged.
Step-by-step instructions on verifying these adjust-
ments can be found in
SECTION 7: SERVICE
ADJUSTMENTS.
Factory adjustments that should be verified:
1. Blade Tracking (Page 32).
2. Squaring the Blade (Page 33).
3. Blade Guide Bearings (Page 34).
Recommended
Adjustments
Figure 26. ON/OFF switch.
Test Run