Grizzly G1010 - Manual (Page 19)

G1010 4" x 6" Metal-Cutting Bandsaw
-17-
8. Install each of the rubber feet on the legs with
two 3 ⁄
8
"-16 hex nuts and two 3 ⁄
8
" flat washers
(see Figure 8).
9. Slide the ends of the handle through the
holes in the legs. Do this on the same end as
the rubber feet (see
Figure 9).
Figure 8. Rubber feet.
Figure 9. Handle installation.
10. With a pair of pliers, insert a cotter pin
through each hole at the end of the handle
and bend back one end of the cotter pin to
secure the handle to the leg.
Components and Hardware Needed: Qty
Bandsaw ............................................................1
Hex Bolts
5 ⁄
16
"-18 x 1" .........................................8
Flat Washers 5 ⁄
16
" ..............................................16
Hex Nuts 5 ⁄
16
"-18 .................................................8
To mount the bandsaw to the stand:
1. With the help of an assistant, set the bandsaw
onto the stand (see Figure 10).
Mounting
Figure 11. Safety bracket installed for shipping.
Figure 10. Setting the bandsaw.
2. Remove the safety bracket with a Phillips
head screwdriver, then tighten down the
switch safety bracket (see
Figure 11).
Safety Bracket
Switch Safety Bracket
Second Washer
and Hex Nut