Grizzly 3HP Dry Spray Booth G0533 - Manual (Page 18)

-16-
Model g0533 (Mfg. since 3/11)
2. Make sure the work table opens and closes
smoothly.
3. reach under the work table and fully extend
the two support legs.
4. lock the latches on the bottom of each cur-
tain into the work table.
2. install six second-stage filters above and
below the middle brace along the inner rails,
as shown in
figure 13.
filters
To install the filters:
1. Install the six third stage filters into the filter
case as shown in figure 12.
figure 14. First stage filters.
figure 13. second-stage filters.
3. Install six first stage filters (figure 14) along
the outer rails.
Ducting
the g0533 dry spray booth must be vented to
the outside of your shop or building using 12"
metal spiral wound ducting or 18 gauge rolled
galvanized steel ducts in accordance with nFpa
33 guidelines.
figure 12. third stage filters (only three shown).
Filter
Case
Middle
Brace
inner
rail
outer
rail
third stage
Filters