GE 25880 - Manual (Page 40)

40
NOTE: If the battery is not properly installed in the handset, or if the battery
pack is not properly connected to the jack inside the battery compartment, NO
BATTERY flashes in the display.
Battery Safety Precautions
• Do not burn, disassemble, mutilate, or puncture. Like other batteries of
this type, toxic materials could be released which can cause injury.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
CAUTION: To reduce the risk of fire or personal injury, only use the
ATLINKS Ni-CAD battery model 5-2548 that is compatible with this unit.
Headset and Belt Clip Operation
Connecting an Optional Headset to the Handset
For hands free conversation, connect the headset
(optional) to the HEADSET jack as shown. The
handset receiver and microphone are disabled when
the headset is connected.
Adjust the headset to rest comfortably on top of
your head and over your ear. Move the microphone
to approximately 2 to 3 inches from your mouth.
• Press the talk/end/call back button to answer or
place a call before using the headset.
Connecting the Belt Clip
There are two slots, one on each side of the handset.
• Attach the belt clip by inserting the sides of the belt clip
into the slots. Snap the ends of the belt clip into place.
NOTE: The RBRC seal on the battery used in your
ATLINKS USA, Inc. product indicates that we are
participating in a program to collect and recycle
Nickel Cadmium batteries throughout the
United States. Please call 1-800-8-BATTERY for
information or contact your local recycling center.
Headset jack
Headset plug
Slot for belt clip