Stovax PM235 RV66AVC - Manual (Page 29)

29
1.4 Using the appliance for the first time:
• Burn at a low output for the first day of use
This allows the seals, fixing glues and paint to fully cure.
1.5 During this time the appliance may give off some
unpleasant odours:
• Keep the room well ventilated to avoid a build-up of
fumes.
1.6 Your Stovax dealer can carry out service and maintenance.
2. REMOVAL OF THE LOG GUARD
2.1 To remove the Log guard:
• Lift Log Guard clear of the supporting brackets
• Rotate to clear the sides of the door opening.
Do not use appliance without the log guard in position.
3. DOOR REMOVAL (ALL)
3.1 See Section 3a and 3b Door Removal Riva - 3a and Avanti -
3b in Installation section.
4. ASHPAN DOOR REMOVAL (RIVA)
4.1 See Section 4 Ashpan Door removal (Riva) in Installation
section.
5. BAFFLE REMOVAL (ALL)
5.1 See Section 5, Baffle Removal (all) in Installation Section.
6. FIREGRATE REMOVAL (ALL)
6.1 See Section 6a and 6b, Firegrate Removal a) Riva and b)
Avanti in Installation Section.
7. BRICK REMOVAL (ALL)
7.1 See Section 7 Firebrick Removal in Installation section.
8. FITTING THE FRAME (RIVA)
8.1 See Section 8 Fitting the Frame in Installation section.
9. FITTING CONVECTION AIR DUCTS
9.1 See Section 9 Fitting Convection Air Ducts in Installation
section.
MAINTENANCE and SERVICING
10. FITTING A NEW DOOR GLASS
ALL MODELS
Door Rope Seal
Fixing Screw
Trim / Frame
Glass Edge
Seal Tape
Glass
Door
1 Riva
Door Rope Seal
Fixing Screw
Trim / Frame
Glass Edge
Seal Tape
Glass
Door
PR7051
2
Riva Avanti
10.1 To maintain the safe use of your appliance you may need to
replace a damaged door glass. To complete this operation:
Riva 66, See 3A
• Remove the door, by opening 25mm, removing the hinge
pins and lifting the door free of the hinge blocks