Grizzly Slow Speed Cold Cut G0665 - Manual (Page 16)

-14-
g0665 slow speed Cold Cut saw
Setup
setup consists of assembling the stand, mounting
the machine to the stand, and attaching the work
stop.
To assemble the machine:
1. Attach the front panel to one of the side
panels with three M8-1.25 x 20 hex bolts and
nuts, as shown in
figure 9.
3. Attach the rear panel to the stand with the
remaining hex bolts and nuts.
Note: If you plan to mount your machine
stand to the floor, do so now (see
Mounting
to Shop Floor on Page 13), then return
to
Step 4, below, to mount the machine to
the stand. Otherwise, continue with Step 4,
below.
figure 9. Front and side panels.
2. Attach the remaining side panel in the same
manner as Step 1, as shown in figure 10.
figure 10. second side panel attached.
Front panel
side panel
side panel
4. place the saw onto the stand and secure it
with the four M8-1.25 X 35 hex bolts ( figure
11).
This machine is very
heavy. Get lifting help or
use power lifting equip-
ment such as a forklift to
place this machine onto
its stand.
figure 11. Mounting saw onto stand.
saw Base
stand
hex Bolt