Grizzly Slow Speed Cold Cut G0665 - Manual (Page 21)

g0665 slow speed Cold Cut saw
-19-
Auxiliary Stability bracket
the auxiliary stability bracket can be placed in
two positions. depending on the angle of the cut,
the bracket may have to be moved to provide
adequate clearance for the blade.
Tools Needed: Qty
hex Wrench 10mm ............................................ 1
To adjust the auxiliary stability bracket:
1. disConneCt sAW FroM poWer!
2. loosen and remove the cap screw and wash-
er shown in figure 22.
figure 22. Auxiliary stability bracket.
3. remove the auxiliary stability bracket and
replace it in the position that does not inter-
fere with the range of motion of the saw
blade.
Note: At angles greater than 30° away from
the vise, it is necessary to remove the auxil-
iary stability bracket entirely.
vise Quick Release Lever
For repetitive cutting procedures that require
frequent clamping and unclamping of the same
size stock, the Model g0665 is equipped with a
quick release lever that allows the workpiece to be
released, repositioned, then quickly reclamped.
To use the quick release lever:
1. disConneCt sAW FroM poWer!
2. rotate the lever clockwise to the upward
position, as shown in figure 23.
figure 23. Quick release lever.
3. open the vise wide enough to accept the
workpiece, then place the workpiece into the
vise.
4. Close the vise to within approximately 1 /
8
" of
the workpiece, as shown in figure 24.
figure 24. Closing vise.
Cap screw
& Washer
Quick release lever
1 ⁄
8
" gap
Vise Jaw
Workpiece
Auxiliary stability Bracket