Grizzly Slow Speed Cold Cut G0665 - Manual (Page 20)

-18-
g0665 slow speed Cold Cut saw
Adjustable vise Jaw
the vise jaw on the Model g0665 can be adjusted
for maximum support while still providing clear-
ance at a variety of cutting angles. the Model
g0665 also features an auxiliary stability bracket
for additional support during cutting procedures.
Tools Needed: Qty
hex Wrench 10mm ............................................ 1
vise
6. tighten the cap screw.
7. return to Step 3 and re-check for clearance.
4. loosen the cap screw until the jaw slides
freely ( figure 20).
figure 20. sliding jaw.
5. slide the jaw so that it is approximately ½"
away from the blade ( figure 21).
Note: At certain angle settings, it may not be
possible to set the jaw within the specifica-
tions described above. If this is the case,
adjust the jaw as far as it can go while still
being securely clamped.
Cap screw
Vise Jaw
figure 21. setting blade clearance.
Jaw
1 ⁄
2
" gap
Blade
To adjust the vise jaw:
1. disConneCt sAW FroM poWer!
2. set the cutting angle, as described in Cutting
Angle on Page 17.
3. lower the saw to check for clearance.
—if the saw blade lowers completely without
touching the vise jaw or stability bracket,
no adjustments are necessary.
figure 19. Adjustable vise jaw.
Vise Jaw
NOTICE
Prior to cutting, both the jaw and stability
bracket must be checked for blade clear-
ance. failure to do this could cause the
blade to contact the vise during the cut,
resulting in damage to the machine.
—if the saw blade hits the vise jaw, perform
Steps 4–7 on this page.
—if the saw blade hits the auxiliary stability
bracket, see Auxiliary Stability bracket
on Page 19.
stability Bracket