Grizzly Slow Speed Cold Cut G0665 - Manual (Page 27)

g0665 slow speed Cold Cut saw
-25-
SECTiON 6: MAiNTENANCE
Always disconnect power
to the machine before
performing maintenance.
failure to do this may
result in serious person-
al injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
•
loose mounting bolts/screws/nuts.
• damaged or worn saw blade.
• Cutting fluid level.
• proper function of blade guard.
• Any other unsafe condition.
• general cleanup to prevent buildup of metal
shavings.
Weekly Maintenance:
•
Clean the machine thoroughly, including the
cutting fluid tank to remove shavings.
• Clean the cutting fluid screens in the machine
base and the tank.
• Check/adjust gearbox oil level.
• Clean/grease the vise leadscrew.
Monthly Check:
•
Check/tighten all machine bolts.
• oil the main saw hinge pin.
Every Six Months:
•
Change gearbox oil.
Schedule
Cleaning the Model g0665 is relatively easy.
Vacuum excess metal chips and wipe off the
remaining debris and cutting fluid residue with a
dry cloth.
Cleaning
protect the unpainted cast iron surfaces on the
machine by wiping the table clean after every
use—this ensures moisture from wood dust does
not remain on bare metal surfaces.
Keep tables rust-free with regular applications of
products like g96
® gun treatment, slipit ® , or
Boeshield ® t-9, all available through the grizzly
catalog or website.
Unpainted Cast iron
vise Leadscrew
1. disConneCt sAW FroM poWer!
2. use a rag to clean any debris from the vise
leadscrew (located on the underside of the
vise assembly).
3. Apply multipurpose grease to the leadscrew
and completely open and close the vise sev-
eral times to distribute the grease.
Note: Periodically clean the leadscrew thor-
oughly with minerals spirits or other degreaser
and relubricate with multipurpose grease.
Lubrication