Genie Z-45 - Manual (Page 21)

Part No. 82600 Genie Z-45/25 & Genie Z-45/25J 19
Operator's Manual Second Edition · Second Printing
Test Drive and Braking
29 Press down the foot switch.
30 Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the drive
chassis, then come to an abrupt stop.
31 Slowly move the drive control handle in the
direction indicated by the yellow arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
drive chassis, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
Test the Drive Enable System
32 Press down the foot switch and lower the boom
to the stowed position.
33 Rotate the turntable until the primary boom
moves past one of the non-steer wheels.
Result: The drive enable
indicator light should come
on and remain on while the
boom is anywhere in the
range shown.
34 Move the drive control handle off center.
Result: The drive function should not operate.
35 Move and hold the drive enable toggle switch to
either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that the
drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform
controls and the drive
chassis to identify the
direction of travel.
FUNCTION TESTS
Blue
Yellow