Genie Z-45 - Manual (Page 29)

Part No. 82600 Genie Z-45/25 & Genie Z-45/25J 27
Operator's Manual Second Edition · Second Printing
OPERATING INSTRUCTIONS
To Drive
1 Press down the foot switch.
2 Increase speed: Slowly move the drive control
handle off center.
Decrease speed: Slowly move the drive control
handle toward center.
Stop: Return the drive control handle to center or
release the foot switch.
Use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Machine travel speed is restricted when the booms
are raised.
Drive Enable
Light on indicates that the boom
has moved just past either non-
steer wheel and the drive
function has been interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Drive Speed Select
· Machine on incline symbol: Low range operation
for inclines
· Machine on level surface symbol: High range
operation for maximum drive speed
Engine Idle Select (rpm)
When the foot switch is not pressed, the engine will
idle at the lowest rpm.
· Turtle symbol: Foot
switch activated low
idle
· Rabbit symbol: Foot
switch activated high
idle
Generator
To operate the generator, move the generator
toggle switch to the on position. The engine will
continue to run but no drive or platform functions
will operate.
Plug a power tool into the power to platform GFCI
outlet.
To resume machine functions, move the generator
toggle switch to the off position. All functions will
operate.