Assembly – Grizzly G0696X User Manual

Page 24

Advertising
background image

g0605X1-6X1, g0696X-97X (mfg. 8/11+)

-21-

Assembly

Assembly steps are the same for all models
except where noted. Assembly consists of install-
ing the front and rear rails, attaching the extension
wing (model g0696X/g0697X) or extension table
and outfeed table (model g0605X1/g0606X1),
then installing minor components.

To assemble the table saw:

1. Fasten the front rail onto the main table with

(4) m8-1.25 x 25 flat head screws, as shown
in

Figure 22.

3. Fasten the rear rail to the table with (4)

m8-1.25 x 25 cap screws, 8mm lock washers,
and 8mm flat washers, as shown in

Figure

23.

G0696X/G0697X Extension Wing

1. inspect the extension wing and main table

mating surfaces for burrs or foreign materials
that may inhibit assembly.

the mating edges of the wing and the table
must be clean, smooth, and flat. Use a wire
brush or file if necessary to clean up the
edges. this step will ensure that the wing
mounts properly to the main table.

4. Fasten the right end of the rail to the pre-

installed extension wing shown in

Figure 23

with (1) m8-1.25 x 25 cap screw, (2) 8mm
lock washers, (1) 8mm flat washer, and (1)
m8-1.25 hex nut.

—if you are assembling the g0696X or

g0697X, continue to the

G0696X/G0697X

Extension Wing instructions below.

—if you are assembling the g0605X1 or

g0606X1, follow the instructions for install-
ing the extension table (

page 23) and

outfeed table (

page 24).

Figure 23. rear rail installed

(model g0605X1 shown).

x4

Extension Wing

2. secure the left side of the front rail to the

pre-installed extension wing with (1) m8-1.25
x 25 flat head screw, 8mm lock washer, and
m8-1.25 hex nut (see

Figure 22).

Figure 22. Front rail installed (model g0605X1

shown).

x4

main table

Extension Wing

x1

x1

Advertising
This manual is related to the following products: