Grizzly G0696X - Manual (Page 52)

g0605X1-6X1, g0696X-97X (mfg. 8/11+) -49-
4. Attach the auxiliary fence to the standard
fence and set it to the desired width.
Note: When figuring out the correct width,
don't forget to account for blade kerf and the
inaccuracy of the fence scale while the auxil-
iary fence is installed.
5. place the workpiece against the auxiliary
fence and slide the resaw barrier against
the workpiece, as shown in
Figure 88. now
clamp the resaw barrier to the table at both
ends.
Auxiliary
Fence
Fence Resaw
Barrier
Workpiece (Front View)
Figure 88. ideal resaw workpiece setup.
The danger of kickback increases relative to
the depth of a cut. Reduce the risk of kick-
back by making multiple passes to achieve
the desired depth of cut. Failure to follow
these warnings could result in serious per-
sonal injury.
Always use push sticks or push paddles to
increase safety and control during opera-
tions which require that the blade guard
and spreader must be removed from the
saw. ALWAyS replace the blade guard after
resawing is complete.
8. plug in the table saw, turn it ON, and use a
push stick or push block to feed the workpiece
through the blade, using a slow and steady
feed rate.
9. Flip the workpiece end for end, keeping the
same side against the fence, and run the
workpiece through the blade.
6. lower the blade completely below the table
and slide the workpiece over the blade
to make sure it moves smoothly and fits
between the resaw barrier and fence.
7. raise the blade approximately an inch, or
close to half the height of the workpiece
(
Figure 89), whichever is less.
11. turn OFF the table saw, then separate the
parts of the workpiece and hand plane the
remaining ridge to remove it.
12. When finished resawing, remove the resaw
barrier and auxiliary fence, re-install the stan-
dard fence face, blade guard/spreader or riv-
ing knife, and standard table insert.
Auxiliary
Fence
Fence
Resaw
Barrier
1 /
8
" Connection
Workpiece
Figure 89. ideal completed resaw cut.
10. repeat Steps 7–9 until the blade is close to
half of the height of the board to be resawn.
the ideal completed resaw cut will leave an
1 ⁄
8
" connection when the resawing is com-
plete as shown in Figure 89. leaving an 1 ⁄
8
"
connection will reduce the risk of kickback.