Grizzly G0696X - Manual (Page 26)

g0605X1-6X1, g0696X-97X (mfg. 8/11+) -23-
G0605X1/G0606X1 Extension Table
1. thread (2) m10-1.5 x 25 hex bolts with 10mm
flat washers onto the right side of the main
table, as shown in
Figure 28. do not fully
tighten the bolts.
5. Align the main table and extension table with
a straightedge, as shown in Figure 31, then
tighten all of the mounting fasteners.
Figure 31. Aligning main extension table.
Figure 30. rear rail/table fastener locations.
x3
4. Fasten the rear rail to the extension table
with (3) m8-1.25 x 25 cap screws, (3) 8mm
lock washers, (6) 8mm flat washers, and (3)
m8-1.25 hex nuts, as shown in
Figure 30.
Finger tighten the hex nuts for now.
Figure 28. hex bolts installed.
x2
2. With the help of an assistant, place the exten-
sion table between the rails and slide the
table slots over the bolts installed in
Step 1.
3. While an assistant holds the extension table,
fasten the front rail to the extension table with
(3) m8-1.25 x 25 flat head screws, 8mm flat
washers and m8-1.25 hex nuts (see
Figure
29). Finger tighten the hex nuts for now.
Figure 29. Front rail/table fastener locations.
x3
6. thread a 3 ⁄
8"
-16 hex nut onto each foot, then
thread the feet into the bottom of the support
legs, as shown in
Figure 32.
Figure 32. Foot installed on support leg.
Foot
support leg
hex nut