GE 49-85179 - Manual (Page 23)

The oven door must be closed and all controls set correctly for the cycle to work properly.
After a Clean Cycle (on some models)
You cannot set the oven for cooking until
the oven is cool enough for the door to be
unlatched.
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven
cools.
If white spots remain, remove them with a
soap-filled scouring pad and rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
n You cannot set the oven for cooking
until the oven is cool enough for the door
to unlock.
n While the oven is self-cleaning, you can
touch the Clock pad to display the time
of day. To return to the clean countdown,
touch the Cooking Time pad.
n If the racks become hard to slide, apply
a small amount of vegetable oil or cooking
oil to a paper towel and wipe the edges
of the oven racks with the paper towel.
GEAppliances.com
How to Delay the Start of Cleaning (on some models)
You can set the oven control to delay-start
the oven, clean for a specific length of time
and then turn off automatically.
Make sure the clock shows the correct time
of day.
Follow the directions in the Before a Clean
Cycle section.
Latch the door.
NOTE: Never force the latch. If the oven
is too hot, you will not be able to slide
the latch. Allow the oven to cool.
Touch the Self Clean pad.
Touch the + or – pads to set the
Clean Time.
The Clean Time is preset for 4 hours and
20 minutes. You can change the Clean Time
to any time between 3 and 5 hours,
depending on the amount of soil in your oven.
If a different Clean Time is desired, touch the +
or – pads until the desired Clean Time is
displayed.
Touch the Start Time pad.
Change the Start Time by touching the + or –
pads. The start time will appear in the display.
Touch the Start/On pad.
The self-clean cycle will automatically begin
at the time set.
While the oven is self-cleaning, you can
touch the Clock pad to display the time
of day. To return to the clean countdown,
touch the Self Clean pad.
The oven shuts off automatically when the
clean cycle is complete, and 0:00 will flash
in the display.
Slide the latch handle to the left as far
as it will go and open the door.
To Stop a Clean Cycle (on some models)
Touch the Clear/Off pad.
Wait until the oven has cooled below the
locking temperature to unlatch the door. You
will not be able to open the door right away
unless the oven has cooled below the locking
temperature.
O
pe
ra
tin
g
In
str
uc
tio
ns
Ca
re
a
nd
C
lea
nin
g
In
sta
lla
tio
n
In
str
uc
tio
ns
Tro
ub
les
ho
ot
in
g
Tip
s
Sa
fe
ty
In
str
uc
tio
ns
Co
ns
um
er
S
up
po
rt
23