GE A8950CC User Manual
Page 23
Pin
1
8
Figure 1. Terminal Block Pin Assignments
Figure 2. RJ45 Socket
(Viewed from the rear of the unit)
8
7
6
5
4
3
2
1
Using the breakout box
A breakout box with a 3’ CAT 5 patch cord
(supplied) can be used to interface to the
Phoenix system. Pinouts are shown in the
tables and figures below.
RJ45-A
RJ45-B
RJ45-C
RJ45-D
2. Connect to the module:
Each contact closure module is shipped with (four) RJ45 cables and (four) breakout
boxes to aid in connecting to the Phoenix. Use the tables below to determine pin out
information for your application. GE Security recommends using shielded cable for all
single ended applications and shielded twisted-pair for all differential formats.
Wire gauge is dependent on copper run length. Refer to manufacturer of data
equipment for specific recommendations.
21