GE A8950CC - Manual (Page 4)

Overview
Installing the Phoenix chassis is a three-step process:
1. Install mounting hardware and power supplies.
2. Install modules and connect cabling.
3. Configure the system.
Determine Mounting Hardware
Mounting brackets are adjustable. Choose the best location to fit your application and
position brackets using the supplied hardware. Remove screws holding front mounting
bracket, move to top, bottom, back or front and refasten.
Installing Power Supplies
All installation should be from rear of rack unit.
To install power supply, slide power supply in slot "A" and secure with hardware. Remove
center support panel and use to cover open slot if redundant power supply is not used.
Optional Redundant Power Supply: When using the redundant power supply, remove panel
and insert second power supply in slot "B" and secure.
** CAUTION:
This product contains ESD-sensitive components. Although all precautions have been made to
reduce ESD susceptibility, use good grounding techniques when handling uninstalled modules
.
2
Getting Started
Specifications
Model A8960AC
Size
Weight
Model Part Number
Optional Redundant Power Supply
A8960AC
1.65 in. W x 3.30 in. H x 8.00 in. D (42 x 84 x 203 mm)
1.25 lb. (5.67 g)
Electrical
• Input power: 100 V to 240 V, 60 Hz
Input power: 105 V to 240 V, 50 Hz
• Current requirement: 2 A
• Power consumption: 40 W
• Protection: 250 V, 2 A fuse
Model
Slot B
Model Part Number
Active fuse
Model Part Number
Spare fuse
Model
Slot A.
Module Installation
The Optical Transceiver is the first module to be installed.