Motorola SB4101 - Manual (Page 30)

X
Home Print Exit
Introduction Before You Begin Installation Configuration Troubleshooting Legal
23
The SB4101 contains all necessary software.
You don't need to configure the SB4101, but
you must configure your computer for TCP/IP
(software protocol developed for
communication between computers) and
check for an IP address. Your service provider
may provide additional instructions for setting
up your computer.
Configuring for TCP/IP in Windows 95,
98, and Me
The following basic instructions are for Windows 95, 98 and Me. Windows 2000
configuration instructions begin on page 26. If you are using a different operating
system, refer to your user guide.
1 On the Windows Desktop, click Start.
2 Select Settings and then Control Panel from the pop-up menus.
3 Double-click the Network icon on the Control Panel window.
4 Select the Configuration tab on the Network window.
5 Check to see if TCP/IP has been installed for the device being used (Ethernet card
or USB). If TCP/IP is displayed in the list of network components, it is installed and
you can proceed to step 10. If TCP/IP is not displayed on the list, continue with
step 6.
6 Click Add.