Multi Tech Equipment MTA128ST - Manual (Page 16)

Configuration Utility
16
Configuring your TA
If you use Windows 98/Me/NT, perform the following procedure using the Configuration Utility provided on your
system CD. If you are using another operating system, you can configure the TA using the firmware-based
configuration utility or AT commands. Procedures for using the firmware-based configuration utility and AT
commands are described in Appendix E.
Before you begin, verify your switch type and TEI with your local ISDN provider and have that information readily
available
1. When installing from CD, insert the MTA1 28ST/NT System CD into your CD ROM drive. When the
MTA1 28ST/NT Terminal Adapter AutoRun screen is displayed, click on the Config Utility icon. Follow
the on screen directions to load the Configuration Utility onto your pc.
2. When the Configuration Utility is loaded onto your pc, click
Start>Programs>ISDNTA Config
Utility.
The Welcome screen is displayed
Do you want the wizard to search for your ISDN TA? with the Yes option enabled. Click Nextto continue.