Multi Tech Equipment MTA128ST - Manual (Page 50)

50
Appendices
A p p e n d i x C : F C C a n d C a n a d i a n R e g u l a t i o n
FCC
1. This equipment complies with Part 68 of the Federal Communications Commission (FCC) rules. On the
outside surface of this equipment is a label that contains, among other information, the FCC registration
number and ringer equivalence number (REN). If requested, this information must be provided to the
telephone company.
2. As indicated below, the suitable jack (Universal Service Order Code connecting arrangement) for this equipment is
shown. If applicable, the facility interface codes (FIC) and service order codes (SOC) are shown.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is
designed to be connected to the telephone network or premises wiring using a compatible modular jack which is
Part 68 compliant. See installation instructions for details.
3. The ringer equivalence number (REN) is used to determine the quantity of devices which may be connected to
the telephone line. Excessive REN’s on the telephone line may result in the devices not ringing in response to an
incoming call. In most, but not all areas, the sum of the REN’s should not exceed five (5.0). To be certain of the
number of devices that may be connected to the line, as determined by the total REN’s, contact the telephone
company to determine the maximum REN for the calling area.
4. If this equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone
company will notify the customer as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
5. The telephone company may make changes in its facilities, equipment, operations, or procedures that could
affect the operation of the equipment. If this happens, the telephone company will provide advance notice in
order for you to make necessary modifications in order to maintain uninterrupted service.
6. If trouble is experienced with this equipment (the model of which is indicated below) please contact Multi-Tech
Systems, Inc. at the address shown below for details of how to have repairs made. If the equipment is causing
harm to the telephone network, the telephone company may request you remove the equipment from the
network until the problem is resolved.
7. No repairs are to be made by you. Repairs are to be made only by Multi-Tech Systems or its licensees.
Unauthorized repairs void registration and warranty.
8. This equipment cannot be used on public coin service provided by the telephone company. Connection to
Party Line Service is subject to state tariffs. (Contact the state public utility commission, public service
commission or corporation commission for information.)
9. If so required, this equipment is hearing-aid compatible.
Manufacturer: Multi-Tech Systems, Inc.
Model Number: MTA128NT
FCC Registration #: AU7USA-24353-DD-N
Ringer Equivalence: Modular Jack (USOC) RJ45/RJ1 1
Service Center in USA: Multi-Tech Systems Inc.
2205 Woodale Drive Mounds
View, MN 55112 Voice (612) 785-
3500/ FAX (612) 785-9874